Sometimes it is expected to miss, but it works

Today, I built a styrene frame for my resin printed interurban boxcar. This is a "beta" car, the final chassis will be printed also.

I screwed the bogies and built a radial coupler from a cannibalized Kadee coupler. Then I attached another improvized radial coupler to my big Suydam Niles. This couplers are neither well finished nor well adjusted.

To my entire surprise, it works.

Not only in pull operation, but also pushing the trailer with excessive high speed through my sharp S-curves.

Two short videos :


No comments:

Post a Comment