Winona Windsplitter H0 scale model

While awaiting the first test print of the Fort Wayne Lightwight Combine, my old Windsplitter project meets some attention. 

The first job is done: the model looks somewhat like a Winona Windsplitter. The general proportions seem mainly ok, when compared to photos. As no side elevation exists from this car, modeling work must be done essentialy with photos. Fortunately, a floor plan were published in reviews when the cars were new. 

Any comment, critic or help is welcome.


  1. Will you make this car available through 3D printing? Thanks, Dave

  2. Obviously, I hope to finish the remaining drawing work in about 4 weeks...