Ft Wayne-Lima Combine - riveting the rounded ends

The riveting of the rounded ends is particular complicated and time consuming. I found a new procedure to accelerate this procedure in Cinema4D. One single rivet is cloned following a given radius and start/end angle. This may speed up the painful riveting work and soon I could start to design the floor plate. A first plate would be prepared for a Bowser PCC drive. With a Hollywood drive this car could be equipped with full interior seating.

The doorsteps will be part of the floor plate this time, as no radial coupler is required for this car.


  1. Nice work Volkmar. I wish you had asked, I could have shared that secret with you.

    So many time saving tricks to 3D work!


  2. Next I time I will ask, because I think that you have some secrets that I haven't...